This page will contain stuff for the moving geometry example for the UGM 2016 presentation.
Basics of transformations
trans s s2 0 0 182.88

Control rod initial position.

trans s s2 0 0 182.88
transv s s2 0 0 750.0
transa s s2 0 0 981.0

Control rod movement. Initial upwards velocity of 750 cm/s. Initial downwards acceleration of 981 m/s^2. Simulation time of 2 seconds with 500 time intervals.

Time limits for transformations
transa s s2 tlim 0.1 0.5 1 0 0 1000.0
transa s s2 tlim 0.5 0.9 1 0 0 1000.0

Control rod movement. Upwards acceleration of 1000 cm/s^2 from 0.1 to 0.5 seconds followed by downwards acceleration of 1000 cm/s^2 from 0.5 to 0.9. Simulation time of 2 seconds with 250 time intervals. Ttype 1.

transa s s2 tlim 0.1 0.5 2 0 0 1000.0
transa s s2 tlim 0.5 0.9 2 0 0 1000.0

Control rod movement. Upwards acceleration of 1000 cm/s^2 from 0.1 to 0.5 seconds followed by downwards acceleration of 1000 cm/s^2 from 0.5 to 0.9. Simulation time of 2 seconds with 250 time intervals. Ttype 2.

transa s s2 tlim 0.1 0.5 3 0 0 1000.0
transa s s2 tlim 0.5 0.9 3 0 0 1000.0

Control rod movement. Upwards acceleration of 1000 cm/s^2 from 0.1 to 0.5 seconds followed by downwards acceleration of 1000 cm/s^2 from 0.5 to 0.9. Simulation time of 2 seconds with 250 time intervals. Ttype 3.
